Shibori Side-Shirred Tshirt

Step 2:

- Using heavyweight thread, sew a ½” running stitch through both layers of the shirt along the chalk lines.

Step 3:

- Pull the thread tight to gather the fabric along both sides and wrap two rubber bands tightly over the gathered lines of stitching.

- Dip shirt in water and squeeze out excess water. Set aside.

Preparing Rit® Dye

- Heat water in the microwave to be sure it is very hot, at least 140º F.

- Wearing rubber gloves, measure and mix dye in disposable containers in the following amounts. Stir well.
¼ cup Teal Liquid Dye with 2 cups hot water
½ cup Fuchsia Liquid Dye with 2 cups hot water

- Wearing rubber gloves, immerse wet T-shirt in Teal dye. Push down on shirt with spoon or rubber gloves to be sure dye penetrates fabric. Then remove shirt and squeeze out excess Teal dye.

- Dip gathered sides of shirt in Fuchsia dye. Squeeze out excess dye.

- Place shirt in shallow dish and cover with plastic wrap. Cover bottom of microwave with paper towels.

- Place plastic-wrapped dish with shirt in microwave and set on High for 2 minutes. Wear rubber gloves or use a pot holder to remove from microwave. Remove plastic wrap. Allow fabric and wrap to cool.

- Remove rubber bands and thread. Rinse shirt under cool running water until water runs clear. Then wash with warm water and detergent; rinse and dry.